It Gives us immense pleasure to introduce an
innovative energy saving device for Gas Geyser. Gas Geyser
wastes more than 50% gas in non usable time from 9pm to 6am,
keeps water hot in the coldest time and also heating it in
most of the day when not required. This device controls the
geyser in the programmed way as per your life style. This
"programmed Timer" saves at least 50% gas by turning off the
geyser when not required. This affects not only reducing the
gas bill but also bringing down the chargeable slab rates.
This Financial saving pays back its cost within two to three
months and also minimizes the gas load shedding in the
country.
PROGRAMMER
Instructions
(Press exit
to get out of the programmer mode at any time)
1.
Set Time
a. Press Edit button
once to enter (clock) minute settings, use the Set
button to adjust minutes.
b. Press Edit again
to enter hour settings, use Set button to adjust hours
2.
Set Program
In 24 hours you have
24 options to turn geyser ON or OFF every hour
a. Press Edit 3rd
time to enter into programming mode. Left two digit
display the hour of program and the right digit shows
ON/OFF (1/0) (Status also shown on left)
b. Use Set button to
ON or OFF the geyser for that hour (from 00:00 to
01:00)(24 hour clock, so for 1 PM, program 13th hr)
c. Press Edit button
again to program next hour
d. Repeat the step
(b)
1.
Boost Mode
If you want to turn the
geyser ON urgently, press boost button for five seconds.
Geyser will be ON for next 2 hours and then revert back
to programmed operations. (boost will appear on left of
screen)
2.
Bypass Mode
In case the timer is not
working properly just rotate the knob parallel to the
burner pipeline, then the geyser will be controlled by
the thermostat.
* After fault is removed
rotate the knob into normal position.
